myWerkzeug.de › CNC.myWerkzeug.de › Templates › Workshop
CNC template · Workshop
Bench hook for sawing
Sawing aid for the workbench: a strip underneath hooks over the bench edge, the strip on top holds the workpiece, both with through tenons. With saw kerfs for 90° and 45°. Size, thickness and fit adjustable.
- Size
- 296 × 342 mm, 15 mm thick
- Material
- Hardwood (beech, oak)
- Difficulty
- Intermediate
- Milling time
- approx. 49 min
- Bits
- V-bit 60°, End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Wood glue (water-resistant D3) |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Mill the mortises, then cut out base plate and both strips. From 17 mm material thickness use an end mill with 22 mm cutting length.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Before gluing, dry-fit everything. If a joint is too tight, increase the clearance by 0.05 mm and carve the part again; if it wobbles, reduce it.
Assembly and final touches
- Glue the fence strip in from the top and the hook strip from the bottom; sand the tenons flush. The two strips sit on opposite edges.
- Once dry, saw the 90° and 45° kerfs into the fence strip with your own saw along the engraved lines: this way the guide fits your saw blade exactly.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
