myWerkzeug.de › CNC.myWerkzeug.de › Templates › Workshop
CNC template · Workshop
Corner clamping squares for gluing
Right-angled clamping aids of multiplex for boxes and frames: relief in the corner against glue squeeze-out, windows for the clamps on both legs. Size and number adjustable.
- Size
- 266 × 266 mm, 18 mm thick
- Material
- Hardwood (beech, oak)
- Difficulty
- Beginner
- Milling time
- approx. 18 min
- Bits
- End mill Ø 6 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Apart from the workpiece you need nothing else.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Mill the clamp windows and corner relief, then cut out the squares with the 6 mm end mill (32 mm cutting length).
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Do not sand the two reference edges, only deburr them, so the right angle stays true.
Assembly and final touches
- Check each square with a try square. For gluing, set it into the inside corner of the box and clamp it to both walls through the windows with two clamps.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
