Two discs on top of each other: through its window the top one shows the table you turn it to, from 1 × n to 10 × n. For practice, say the results first, then check. All engraved, for router and laser.
- Size
- 464 × 236 mm, 4 mm thick
- Material
- Plywood
- Difficulty
- Beginner
- Milling time
- approx. 18 min
- Bits
- V-bit 60°, End mill Ø 2 mm, End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Binding screw or 5 mm dowel with two washers |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Engrave numbers and lines, window and centre hole with the 2 mm end mill, then cut out both discs.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Lightly break the edges with sandpaper (grit 120, then 240) and remove burrs.
Assembly and final touches
- Put the small disc on the large one and connect them in the middle with a binding screw or a piece of dowel with two washers; the top one must turn easily.
- Turn the pointer to a number on the edge: the window shows the results of that table next to 1 × to 10 ×.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
