Dice game on a board from 1 to 100 in a zigzag: ladders take you up, slides take you down. Everything engraved, plus four pawns with their own symbols. For two to four children who know numbers up to 100.
- Size
- 300 × 326 mm, 6 mm thick
- Material
- Plywood
- Difficulty
- Beginner
- Milling time
- approx. 43 min
- Bits
- V-bit 60°, End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Wood paints or acrylic paints |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Engrave grid, numbers, ladders and slides, then cut out board and pawns.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Lightly break the edges with sandpaper (grit 120, then 240) and remove burrs.
Assembly and final touches
- Colour in the ladders and slides, the pawns in four colours. Play goes from 1 to 100 in a zigzag.
- Land at the foot of a ladder and you climb up; land at the top of a slide and you slide down. The first to land exactly on 100 wins.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
