myWerkzeug.de › CNC.myWerkzeug.de › Templates › Workshop
CNC template · Workshop
Wall rack for screwdrivers
Wall shelf with holes from small to large for screwdrivers, files and awls, mortised onto two brackets. Number of holes and largest diameter adjustable.
- Size
- 414 × 204 mm, 12 mm thick
- Material
- Plywood
- Difficulty
- Intermediate
- Milling time
- approx. 32 min
- Bits
- End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 3 | Wood screws 4 × 35 mm with wall plugs |
| 1 | Wood glue (water-resistant D3) |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- First the holes and mortises, then carve the outlines with the 3.175 mm end mill (17 mm flute length).
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Before gluing, dry-fit everything. If a joint is too tight, increase the clearance by 0.05 mm and carve the part again; if it wobbles, reduce it.
Assembly and final touches
- Push the tenons of the shelf into the upper mortises of the back, then the two brackets from below into shelf and back. A little glue in the mortises makes it permanent.
- Screw the back to the wall with three screws and plugs, levelling the shelf with a spirit level.
- Finally oil, wax or varnish; for toys use oils or varnishes that are saliva-resistant according to EN 71-3.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
