myWerkzeug.de › CNC.myWerkzeug.de › Templates › Workshop
CNC template · Workshop
Angle gauges for mitres
Seven right-angled gauges for 15°, 22.5°, 30°, 36°, 45°, 60° and 72°: for setting saw and sliding bevel, for octagons, hexagons and pentagons. Each with engraved degrees and angle arc.
- Size
- 328 × 180 mm, 3 mm thick
- Material
- Acrylic (PMMA)
- Difficulty
- Beginner
- Milling time
- approx. 26 min
- Bits
- V-bit 60°, End mill Ø 2 mm
- Customise
- Size, text and details adjustable with sliders
Free with an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Key ring |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Engrave degrees and arcs, mill the ring holes, then cut out the gauges.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Only deburr the edges at the acute angle so they stay accurate.
Assembly and final touches
- Check each gauge once with a protractor. For setting up, put the long edge against the saw blade and the short one against the fence.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
